Page 1 of 1
Scaling Problem...
Posted: Mon Aug 20, 2007 4:45 pm
by Shane Stump
Setting the page top / bottom margins to a value > .6" (inches) causes the first column in tables to be "cut-off". The rendering code isn't handling the scaling properly.
I will see about getting you a test document.
Best Regards,
Shane
Re: Scaling Problem...
Posted: Tue Aug 21, 2007 8:32 am
by proxy3d
send example of the document on
[email protected]
Posted: Tue Aug 21, 2007 11:06 am
by Shane Stump
I will get it to you later today.
Best Regards,
Shane
Re: Scaling Problem...
Posted: Tue Aug 21, 2007 10:39 pm
by Shane Stump
I fixed the problem by calling the functions NoPagesMode() + PagesMode() (that I copied from ActionTest) after a Page Setup operation.
Best Regards,
Shane
Re: Scaling Problem...
Posted: Wed Aug 22, 2007 6:15 am
by proxy3d
please, send example of the document on
[email protected]